S&S Limited Travel Spacer Kit for Hydraulic
Tappets. Designed to maximize the efficiency of
the stock hydraulic tappets. Kit consists of four
(4) machined heat treated and ground spacers
when installed in the tappets. They reduce
the travel of the hydraulic unit in high RPM
situations thereby eliminating potential damage
to the engine due to high RPM valve float. Under normal conditions
they allow the tappets to operate as designed resulting in low valve
train maintenance and minimal noise.
VT No. 10-8532
Adjustable Evo Pushrod Sets.
VT No. Style Year
11-9536 Solid 1984-Early 85
Pushrod Sets are
designed to be installed
without removal of rocker
boxes or cylinder heads.
Precision made from 4130
chromoly tubing. Fits Evo
Big Twins 1984-99.
Tapered Adjustable Pushrods are manufactured from 4130
steel with hardened adjusters and ball ends. Designed to be
installed without removing gas tank, rocker box or camshaft
cover. Set of four. Fits Evo Big Twin hydraulic or solid.
E-Z Pushrod Sets designed
to be installed without remov-
al of the heads or rocker
boxes. Rods feature chro-
moly tube construction with
rolled thread adjusters. Fits
VT No. 11-7713
Andrews E-Z Install Evo 80
Pushrods are available in either
aluminum (6061T6) or steel (4130
moly). Kits include four adjust-
able steel or aluminum pushrods
which will install without removing
tanks or rocker boxes.
VT No. Type
11-9224 Chromoly Steel
Solid Tappet Adapter Kit permits use of hotter cam to run
solid tappets by deactivating the hydraulic portion of the stock
tappets, uses stock pushrods for 1340 models.
VT No. Fits
V-Thunder Evo Pushrod Sets are made from .049 wall 4130
chromoly steel. Exacting tolerances for reliability. VT No.
11-7712 is a 2-piece style which can be removed or installed
without disassembling heads. These rods fit stock or Velva
Touch Tappet units.
*Note: Saves time without the disassem-
bling of the heads or tappet blocks
With stock hydraulic tappets
With long stroker cylinders
Andrews Pushrods available
in chromoly steel or aluminum,
adjustable or fixed type as
noted. All are stock diameter, so
there is no cover interference.
Some items on this page may be emission-related parts subject to California or other emission control laws. Please see
note for important information regarding emission control regulatory compliance and warranty information.
Crane Adjustable Pushrods
made from aircraft grade
seamless 4130 chromoly steel
tubing and heat treated to
128,000 psi tensile strength
for a stronger and lighter than
stock pushrod. New style
adjuster helps minimize the
effects of poor geometry found
in stock pushrods, the smaller
diameter eliminates pushrod
“rub” completely. Set contains
two intake and exhaust push-
rods. These are not the time